Here is a short list of some features of LS1-edit:

Engine Control:

Limiters:

• four Idle Speed Tables
• Five RPM Limits
• RPM limit By Gear Table
• RPM Limit by Temperature
• RPM Limit Delay

Fuel:

• Fuel Air Ratio Table
• Volumetric Efficiency Table
• MAF calibration Table
• Fuel Pressure versus voltage
• Fuel Injector flow rate Manifold vacuum
• Fuel injector Offset Table
• Power Enrichment vs Temp Table
• Power enrichment versus RPM Table
• Wide Open Throttle Hot & Cold Tables
• Closed Loop Enable vs Temperature

Timing:

• High and Low Octane Spark Adv. vs RPM vs Load
• Base Spark Advance in Gear, and In neutral Tables
• four Knock retard Tables
• 3 Torque Management tables
• 6 Knock Learn Parameters
• Maximum Torque Parameter

Engine Diagnostics:

You can change the mode of 64 different Diagnostic Tests

Transmission:

A4 Shift Speed

• Normal Mode Shift Speed vs Throttle position for each Up and Down Shift
• Performance Mode Shift Speed vs Throttle position for each Up and Down Shift
• Wide Open Throttle Shift Parameters

A4 Shift Firmness

• Force Motor Current vs Temperature vs Throttle Position
• Desired Shift time vs Torque for each Up and Down Shift
• Torque Reduction vs RPM

TCC lock tables

• Normal Mode TCC lock speed for each gear by Throttle Position
• Performance Mode TCC lock speed for each gear by Throttle Position
• Cruise Mode TCC lock speed for each gear by Throttle Position
• Normal Mode TCC release speed for each gear by Throttle Position
• Performance Mode TCC release speed for each gear by Throttle Position
• Cruise Mode TCC release speed for each gear by Throttle Position

M6 CAGS

• Six control parameters

System

• Fan Temperature
• VATS disable

Speedometer

• Gear and Tire size scaling
• Speed Limiters

Back to the LS1 Main page